The SMART TRAY© is the only cavity tray system available in the UK that can be installed via a single cut in the masonry. View Pictures

Traditional cavity trays which are fitted after the wall has been built usually require a minimum removal of two courses of bricks above the affected area. Due to mortar colours and salting of new cement works, the result can be very unsightly.
As the SMART TRAY© is fitted through a single cut, brickwork is left in most cases unaffected. The only visible signs of the works are the front tray edge and the weep holes, usually at two brick intervals.

Due to its unique design, the SMART TRAY© offers a neat and effective cure for penetrating damp. It can also be fitted in a fraction of the time required for a traditional cavity tray and this is reflected in a very competitive installation cost.

The SMART TRAY© comes in two formats:

The integral flashing tray eliminates the need for costly and intrusive 'stepped' cavity trays.

The SMART TRAY© can also be installed in chimney stacks which are suffering from penetrating dampness.
The Tray creates a barrier to prevent ongoing soaking problems of weathered stacks, a common problem on older properties in particular stacks that are sited close to an interior ceiling or new loft conversion, which needs to be damproof.

All SMART TRAY© installations come with a 10 year back up guarantee

For further information or a no obligation quotation please contact
Mr. M. Hamer LCG. T.eng.

(contact details on the About Us Page)

Installations carried out throughout the UK and Europe

The SMART TRAY© cavity wall system complies fully with building regulations BS 5628-3:2001 Part A 5.3.3.1 Cavity trays over cavity bridges. Part A 5.3.8.2 Cavity trays at roof abutments.

For further technical information please contact Mr. M. Hamer LCG.T. Eng. at the above registered office.